SuperPro Front Replacement Ball Joint (for Fixed Offset Control Arm) for VW Amarok 2H 4MOTION 2010-2022

This kit contains one replacement heavy-duty high-articulation ball joint for the SuperPro fixed offset Upper control arm. The kit contains a brand-new ball joint, which also includes a new dust boot, circlip, nut and any other required installation hardware.
Notes: If both ball joints need replacing, two kits will be required.
This kit is used to replace the ball joint in the following part numbers:TRC6630

Upgrade your 4WD with a SuperPro 4x4 Control Arm! Gain extra clearance, articulation, correct alignment and install a stronger control arm designed for harsh off road conditions.

• Lifetime Warranty
• Enhances your 4WD's handling and performance
• Designed to solve alignment issues when you lift your 4WD
• Approved Nationally - VSB 14 Compliant (ADR compliant)
• High quality, form factor welding and assembly
• High grade Steel, for increased strength

For every inch a vehicle is raised the vehicles geometry is permanently changed, causing alignment issues. If a lift kit is installed, then a control arm should also be installed to solve alignment issues.

SuperPro's 4WD control arms are manufactured, tested and designed in Australia, ensuring high quality development and manufacturing with local reliable resources. SuperPro 4WD control arms are built to meet the high quality requirements set by SuperPro’s Q&A team; designed to outperform both competitor and OE products. Following our business motto ""Engineered to Outperform"", SuperPro exceeds many design expectations and has been certified as such.

Tech. Info:

Reference: KIT6630RK

Weight: 0.4

Note: Control Arm Replacement Ball Joint for Fixed Offset Control Arm - replacement Ball Joint to suit TRC6630 only - Front Axle

Suitable for:

VW AMAROK 2010-2022 | AMAROK 2H 4MOTION